POST-LCD: ISA/PCI Port 80/84H Post Error Debug Card
- Post error codes from ISA or PCI slot (2 in 1).
- Three LEDs to monitor +5Vdc, +12Vdc, and -12Vdc.
- Four LEDs indicate BIOS vendor (Award, AMI, Phoenix, and ??.
- Two LEDs indicate either port 80h or 84h.
- Two 7_segment LEDs to display POST codes on a Black Box.
- One 10" cable connect to a Black Box.
- Select the AMI/Award/Phoenix jumper and display the detail
Post code message on one 2x16 characters LCD display.
- AMI, AWARD, and Phoenix BIOS post error codes.
POST-PCI: PCI Port 80H Post Error Debug Card
- Insert this debug card to PCI slot only.
- Four 7_segment LEDs to display Post codes (two on
component side and two solder side.
- Two Box Post Pin Headers and two 16" cables to display
Post Code on ADP-01.
- Select the AMI/Award/Phoenix jumper and display the detail
Post code message on one 2x16 characters LCD display.
ADP-01: 16" Ribbon Cable for POST-IP and POST-PCI
- 2 pieces of 16" ribbon cable.
- Two 7_segment LEDs to display Post codes.
POST-IP: ISA/PCI Port 80/84H Post Error Debug Card
- Post error codes from ISA or PCI slot (2 in 1).
- 4 LEDs to monitor +5Vdc, +12Vdc, -12Vdc and 3.3Vdc Standby.
- Power Management Event (PME#) switch to wake up or turn on system.
(note: Motherboard needs to enable PME# in CMOS setup).
- AMI, AWARD, and Phoenix BIOS post error codes.
- Four 7_segment LEDs to display Post codes (two on
component side and two solder side.
- Two Box Post Pin Headers and two 16" cables to display
Post Code on ADP-01.
POST-ISA: ISA Port 80H Post Error Debug Card
- Insert this debug card to ISA slot only.
- Five LEDs to monitor 5Vdc, I/O read, I/O write,
Memory read, Memory write.
- Two 7_segment LEDs to display POST codes on component side.
- AMI, AWARD, and Phoenix BIOS post error codes.
OS-IP: Open/Short ISA/PCI Troubleshooting Card
- Read 0/1 for every signal from the LED display.
- Troubleshooting without an oscilloscope.
- Testing Probe.
OS-AGP: Open/Short AGP Troubleshooting Card
- Read 0/1 for every signal from the LED display.
- Troubleshooting without an oscilloscope.
- Testing Probe.
OS-SLOT1: Open/Short Slot 1 Troubleshooting Card
- Read 0/1 for every signal from the LED display.
- Troubleshooting without an oscilloscope.
- Testing Probe.
|
